Sep 21, 2020 Leave a message

The Problem Between Ultrasonic Generator, Transducer And Horn

The problem between ultrasonic generator, transducer and horn

It should be emphasized that the ultrasonic transducer itself is not an energy generator, it is just an energy converter. It converts electrical energy into sound energy (mechanical energy). Under the premise that the input (drive power) and output (amplifier, ultrasonic mold) are well matched, it can convert (output) a large amount of energy.

20khz41

It should be emphasized that the ultrasonic transducer itself is not an energy generator, it is just an energy converter. It converts electrical energy into sound energy (mechanical energy). Under the premise that the input (drive power) and output (amplifier, ultrasonic mold) are well matched, it can convert (output) a large amount of energy.


Input matching refers to the matching between the transducer and the ultrasonic power supply. If the output is well matched but the input is not well matched, the transducer is weak and the welding is not strong. If the output matching is not good but the input matching is good, the transducer will be overloaded, causing chip dislocation, cracking, broken screw, aluminum cracking or burning the power tube of the electric box. For example, like a car slamming on the accelerator in neutral gear, the engine must be easily damaged.


The matching of the transducer and the driving power supply mainly has 4 aspects, namely impedance matching, frequency matching, power matching and capacitive reactance matching.


Frequency matching is also very important. This is firstly because the ultrasonic transducer can only work at its resonance frequency, so the drive power supply, horn, and welding die (tool head) should all work at this frequency.


Power matching and impedance matching mainly consider that the ultrasonic welding system works in the gap, and the load changes greatly. There must be sufficient power output during welding, and the minimum amplitude should be controlled when there is no load. Otherwise, as mentioned earlier, if the input is too large without a load, the transducer will be damaged. The power will not rise at full load, and it will be useless if the welding is not strong.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry