Principle of ultrasonic plastic welding
When ultrasonic waves act on the thermoplastic contact surface, tens of thousands of high-frequency vibrations are generated every second. This high frequency vibration reaches a certain amplitude. Ultrasonic energy is transmitted to the welding area through the upper weldment. Because the welding area is two. The acoustic resistance at the welding interface is large, so local high temperatures are generated. Also due to the undesirable mutation of the plastic, it cannot be emitted in a period of time and gather in the welding area, causing the contact surface of the two plastics to melt rapidly. After a certain amount of pressure is applied, when the ultrasound stops acting, the pressure is allowed to continue for a few seconds, and then it is transformed into solidification to form a solid molecular chain to achieve the purpose of welding. The welding strength can be close to the strength of the raw material.
The quality of ultrasonic plastic welding depends on the amplitude of the transducer welding head, the applied pressure and the welding time. Welding time and welding head pressure can be adjusted. The amplitude is determined by the transducer and horn. The interaction of these three quantities has an appropriate value. When the energy exceeds a proper value, the melting amount of the plastic is large and the welding material is easily deformed; when the energy exceeds the proper value, the welding material is easily deformed. When the energy exceeds the appropriate value, the plastic is easily melted. When the energy exceeds an appropriate value, the welding material is easily deformed. If the energy is small, it is difficult to weld firmly, and the pressure applied cannot be too large. The optimal pressure is the product of the side length of the welded part and the optimal pressure per 1mm edge.





