Introduction of Ultrasonic Plastic Welding Machine Accessories
The use of ultrasonic plastic welding machines is increasing. Some manufacturers buying new equipment do not fully understand the structure and performance of ultrasonic plastic welding machines. Once the ultrasonic plastic welding machine fails, the communication is usually poor. The manufacturer of the ultrasonic plastic welding machine pointed out that I do not know the parts of the welding machine. This is an introduction to ultrasonic plastic welding machine parts.
1. Counter: Record the number of working cycles.
2. Adjustment and pressure gauge: used to indicate working pressure and pressure adjustment.
3. Setting of hardening time: After vibration, adjust the cooling setting time of the welding part of the workpiece to 0-9,99 seconds.
4. Delay time setting: adjust the starting vibration time, and start vibration 0-9 after 99 seconds after activating the limit switch.
5. Sound wave adjustment: adjust the resonance matching between the vibrator system and the vibrating circuit to achieve the ideal conversion efficiency.
6. Splicing time setting: At the end of the delay time, adjust the length of the splicing time and vibrate in the range of 0-9.99 seconds.
7. Amplitude meter: display the amplitude of sound waves when there is no load or no load.
8. Frequency indication: display the machine frequency when debugging the machine
9. Descending speed adjustment: adjust the descent speed reasonably and appropriately.
10. Output cable and socket: used to connect the vibration subsystem of the fuselage and the line of the vibration box.
11. Fuse holder: overload protection of electronic circuits.
12. Power switch and indicator light: control power switch and signal indicating open circuit
13. Welding head: transfer vibration energy to the workpiece for welding.
14. Selection switch (automatic/manual/sonic inspection): automatic or manual selection, and a button for sonic no-load inspection.
15. Up/down buffer adjustment: The adjustment hole is located on the side of the machine, which can be adjusted appropriately to make the lifting inertia moderate.
16. Horizontal fine-tuning screws: Adjusting these four screws can make the welding head evenly fixed on the work object.
17. Low-point fine-tuning screw: When welding glass frit or requiring precise dimensions, it can be used to limit the lowering of the cylinder.
18. Welding position window: In the normal welding process, check the state of the welding head pressing the workpiece.
19. Control cable and socket: used to connect the automatic control circuit and vibration box of the body control unit.
20. Sound wave output adjustment button: used to set the number of sound wave output levels, generally 1~2 level, strong output is 3~4 level.
21. Grounding nut: used to connect the grounding wire of the electronic circuit to ensure safety in the event of leakage.
22. Sonic overload indicator: It displays the abnormality of the sonic overload, so it is necessary to adjust the sonic wave until the overload indicator is not displayed.





