Construction of the ultrasonic cutter generator:
1. Power generator (power frequency current is converted to high frequency current, cutting process control center);
2. Transducer (high-frequency current can be converted into mechanical vibration energy, there is a voltage ceramic magnetic sheet inside, which is extremely easy to damage);
3. Booster (changes the amplitude and acts as a nip point);
4. Horn (Cutting knife).
Maintenance of ultrasonic cutting system components:
Maintenance of the power generator:
1. It is recommended to use an air filter device, to clean and replace it regularly;
2. Working environment temperature is between 5-50 ℃;
3. Generator to avoid being too close to the ground to prevent dust from entering;
4. Ensure that the inlet and exhaust ports are clear;
5. Generator away from radiation or hot vents;
6. Regularly clean the necessary parts.
Transducer maintenance:
1. Reduce the generation of heat;
2. Reduce the impact;
3. The transducer only serves as an auxiliary clamping force, and it is strictly forbidden to use excessive clamping force;
4. Use an air cooling system when the temperature is too high;
5. Regularly clean the dirt on the contact surface of the booster.
Maintenance of the booster
1. Carefully installation and removal;
2. Reduce the impact;
3. The torque of the connecting bolt should not be too large.
Maintenance of the cutting knife:
1. Careful installation and removal;
2. Reduce the impact;
3. Regularly clean the residue on the cutting knife.
Find a professional ultrasonic cutting machine?
Click Altrasonic Technology to realize it!
